Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
- Brake system
   System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
   Replacement of brake shoes of disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Condition check, removal and installation of a brake disk
   Replacement of boots of drum-type brake mechanisms of back wheels
   Removal and installation of wheel cylinders
   Removal and installation of the main brake cylinder
   Check of a condition and replacement of brake lines and hoses
   Pumping of brake system
   Check of serviceability of functioning/tightness, removal and installation of assembly of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Cable replacement (ов) drive of the parking brake
   Check of serviceability of functioning, replacement and adjustment of the sensor switch of stoplights
   Check of serviceability of functioning and replacement of the sensor switch of level of brake liquid
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal and installation of wheel cylinders

In case of leaks wheel cylinders are subject to replacement without fail. Manufacturers do not recommend to undertake attempt of carrying out regenerative repair of these knots of brake mechanisms.

REMOVAL

 PERFORMANCE ORDER

1. To Poddomkratta a car back also establish it on props. Prop up forward wheels protivootkatny boots.
2. Remove a brake drum and boots (see. Section Replacement of boots of drum-type brake mechanisms of back wheels).
3. Clear the wheel cylinder and surfaces surrounding it of dirt.

4. Disconnect the hydraulic line from a back part of the wheel cylinder. In order to avoid a rounding off шлицов the union use a special cap natural a cutting head. At a detachment do not pull for a metal tube of the brake line in order to avoid its deformation, capable it is essential to complicate connection procedure. At once закупорьте the open end of the brake line for the purpose of minimization of losses of liquid and in order to avoid hit in hydraulic system of dirt.

5. Disconnect the hydraulic line from a back part of the wheel cylinder (see an accompanying illustration). In order to avoid a rounding off шлицов the union use a special cap natural a cutting head. At a detachment do not pull for a metal tube of the brake line in order to avoid its deformation, capable it is essential to complicate connection procedure. At once закупорьте the open end of the brake line for the purpose of minimization of losses of liquid and in order to avoid hit in hydraulic system of dirt.

If on frictional overlays of brake boots there are traces of hydraulic liquid, it is necessary to replace boots, and a working surface of a drum carefully to smooth out.

INSTALLATION

 PERFORMANCE ORDER

1. Grease interfaced surfaces of the wheel cylinder and a brake board with RTV hermetic. Establish the cylinder on the regular place and connect to it the hydraulic line. Do not tighten while a shtutserny nut.
2. Screw fixing bolts and strongly them tighten. Now it is possible to tighten a shtutserny nut finally. Establish into place bashmachny assembly.
3. Pump over brake system (see. Section Pumping of brake system).
4. Before starting car operation, make sure of serviceability of functioning of brakes.