Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
- Brake system
   System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
   Replacement of brake shoes of disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Condition check, removal and installation of a brake disk
   Replacement of boots of drum-type brake mechanisms of back wheels
   Removal and installation of wheel cylinders
   Removal and installation of the main brake cylinder
   Check of a condition and replacement of brake lines and hoses
   Pumping of brake system
   Check of serviceability of functioning/tightness, removal and installation of assembly of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Cable replacement (ов) drive of the parking brake
   Check of serviceability of functioning, replacement and adjustment of the sensor switch of stoplights
   Check of serviceability of functioning and replacement of the sensor switch of level of brake liquid
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Cable replacement (ов) drive of the parking brake

 PERFORMANCE ORDER

1. Prop up protivootkatny boots forward wheels, weaken nuts of fastening of back wheels, then поддомкратьте a back of the car and establish it on props.
2. On the models equipped with drum-type brake mechanisms of back wheels, remove a brake drum (ы) (see. Section Replacement of boots of drum-type brake mechanisms of back wheels).

3. Weaken an adjusting nut on equalizer assembly (see. Section Adjustment of the parking brake). Disconnect a cable from the equalizer and remove from a cable cover intermediate clamps.

4. On models with drum-type brake mechanisms of back wheels remove bashmachny assembly (see. The section Replacement of boots of drum-type brake mechanisms of back wheels) also disconnect a driving cable of the parking brake from the executive lever on a back boot. Wring out lock uvulas on the holder of a cover of a cable and by means of nippers or a special key on 12 mm liberate a cable from a board of the brake mechanism.

In the absence of near at hand special key it is possible to use a small screw clamp.

5. On models with disk brake mechanisms of back wheels for a cable detachment from the executive lever it is necessary to remove a clip and to take a pin of fixing of a cutting finger (see. Section Replacement of boots of drum-type brake mechanisms of back wheels). The cover of a cable is in addition fixed in an arm by a spring clamp.
To 6 Otboltita arms of intermediate clamps of fastening of a cable to the car bottom. Remove a cable, remembering a route of its laying.

Probably, it is necessary to turn out also bolts of fastening of the back thermofilter of system of production of the fulfilled gases.

7. In case of need remove the second driving cable, operating in a similar manner.
8. Installation is made upside-down. Do not forget to execute adjustment of a drive lay a brake.