Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
- Coupling and power shafts
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter

CHECK

 PERFORMANCE ORDER

1. The sensor switch of disconnection of a chain of a starter is located near the top end of a pedal of coupling. Two wires are brought to the sensor switch, one - from the relay of inclusion of the starter, by the second - weight. At an ignition key povorachivaniye in the situation START and squeezing of a pedal of coupling, at the expense of sensor switch operation, there is a short circuit on mass of the relay of a starter that leads to activation of the electromotor of the last.

2. If the engine is not turned at the squeezed-out pedal of coupling, it is necessary to make sensor switch adjustment, then to repeat attempt. If adjustment does not help to achieve desirable result, check a condition of the sensor switch and in case of need replace the last. If the engine is started at the released pedal of coupling, adjust the sensor switch and repeat attempt.
3. If when squeezing a pedal of coupling the engine is not turned, therefore, or conductivity between sensor switch plugs is broken, or on the last a food from the starter relay does not move.
4. Check serviceability of giving of a food by means of the voltmeter or a lamp sampler. At an ignition key povorachivaniye in the situation START and pedal squeezing on a wire going from the relay of a starter tension should take place. If tension is absent, check on break electroconducting between the relay and the sensor switch. If a food moves regularly, check tension existence from the opposite side of the sensor switch (at the squeezed-out pedal of coupling). Tension existence from both parties of the sensor switch confirms serviceability of its functioning. Try to make adjustment. In the absence of tension replace the sensor switch.

REPLACEMENT

 PERFORMANCE ORDER

Disunite the electroconducting socket, weaken an adjusting nut and turn out the sensor switch from the basic arm. Installation is made upside-down.

ADJUSTMENT

 PERFORMANCE ORDER

Weaken a lock-nut and, rotating the sensor switch, achieve conductivity existence between its plugs at the squeezed-out pedal of coupling.