Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
- Coupling and power shafts
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Adjustment of a pedal of coupling

Pedal height

The distance from its slip to the floor panel is called as height of provision of a pedal. If the result of measurement of this distance falls outside the limits an admissible range, it is necessary to make the corresponding adjustment.

For adjustment of provision of a pedal weaken a lock-nut of the sensor switch of coupling or an adjusting bolt and turn out the switch so that it ceased to adjoin to a pedal. Now weaken a lock-nut of a pusher and, rotating the last, correct in a demanded way height of provision of a pedal. Tighten a lock-nut.

The coupling sensor switch - bottom from two nearby with each other (the top block the sensor switch of disconnection of a chain of a starter is).

Rotating a sensor switch/bolt clockwise, bring it into contact to the pedal lever, then tighten on 3/4 turn/turn. Tighten a lock-nut.
Adjust the sensor switch of disconnection of a chain of a starter (see. Section condition Check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter).

Free wheeling of a pedal

The distance on which the pedal moves is called as a free wheeling, without meeting resistance and without causing coupling operation. At an exit of size of a free wheeling of a pedal out of limits of an admissible range it is necessary to make the corresponding adjustment.

For adjustment of a free wheeling weaken a lock-nut on a pedal pusher, then, rotating a pusher, achieve demanded result. Tighten a lock-nut.
Make sure of correctness of adjustment of the sensor switch of disconnection of a chain of a starter (see. Section condition Check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter).