Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
- Coupling and power shafts
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling

Remember that developed in the course of wear of frictional overlays of a conducted disk of coupling the dust can contain unhealthy asbestos. Do not blow off a dust the compressed air and try not to inhale it. Do not apply to rubbing of components of coupling solvents on an oil basis, - use only special brake cleaners or pure methyl alcohol. The used rags put in tightly closed container.

REMOVAL

 PERFORMANCE ORDER

1. To Otboltita the executive cylinder of coupling (see. The section Removal and installation of the executive cylinder of coupling), without disconnecting from it the hydraulic line going from the main cylinder. Take the cylinder aside and tie up it a wire.
2. Remove a transmission (see. Section Removal and RKPP installation).

3. Remove from a pin of primary shaft vyzhimny the bearing, disconnect holding spring of a fork of switching off of coupling from a spherical finger of a spherical support and remove a fork.

CHECK

 PERFORMANCE ORDER

1. Holding the bearing for an external holder, press internal and повращайте it. The bearing should rotate freely and silently, otherwise it is necessary to replace it. Wipe the bearing pure rags and examine on existence of signs of wear, cracks and other mechanical damages. Usually replacement of the vyzhimny bearing is made each time at service of components of coupling. At all do not wash out the bearing in solvent in order to avoid violation of tightness of its assembly.

2. Check the lever of switching off of coupling on existence of cracks and signs of deformations.

INSTALLATION

 PERFORMANCE ORDER

1. Fill an internal flute of the vyzhimny bearing refractory greasing. With the same greasing slightly grease shlitsa of a pin of primary shaft of a transmission and the holder of the bearing of the last.

2. With the same greasing grease a nest under landing of a spherical finger from a reverse side of a fork of switching off, and also a nest under landing of a pusher of the executive cylinder.

3. Enter vyzhimny the bearing into gearing with a fork of switching off of coupling.
4. Put on the bearing on the holder of the forward bearing of primary shaft of a transmission, at the same time passing the end of a fork of switching off through an opening in a coupling casing. Densely plant a switching off fork on a sharovy finger of a spherical support.
5. Slightly grease with refractory greasing contacting to petals of a diafragmenny spring a surface of the vyzhimny bearing.
6. Further installation is made as it should be, the return to an order of dismantle of components.