Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
- Coupling and power shafts
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal and installation of the executive cylinder of coupling

REMOVAL

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. To Poddomkratta the car also establish it on props.
3. Disconnect the hydraulic line from the executive cylinder of coupling. By means of a hammer and a drift beat out from the cylinder a cylindrical pin and disconnect the union. Prepare dry rags for collecting spilled liquid.
4. Turn out two fixing bolts.
5. Remove the executive cylinder.

INSTALLATION

 PERFORMANCE ORDER

1. Establish the executive cylinder on the regular place on a dome of coupling and tighten with demanded effort fixing bolts. Track correctness of landing of a pusher in a pocket of a fork of switching off of coupling.
2. Replace a sealing ring of shtutserny connection and fill the hydraulic line in a reception nest in the cylinder. Plant into place a fixing cylindrical pin.
3. Fill in in the cylinder necessary amount of brake DOT 3 liquid.
4. Pump over hydraulic system (see. The section air Removal from a hydraulic path of a drive of switching off of coupling).
5. Lower the car on the earth and connect a negative wire to the battery.