Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
- Coupling and power shafts
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal and installation of the main cylinder of coupling

REMOVAL

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Under the dashboard take a pin and disconnect from a coupling pedal a cutting finger of a pusher of the main hydraulic cylinder.

3. Disconnect the tank of the main cylinder of coupling. Самоконтрящимися nippers press the submitting hose connecting the tank to the main cylinder.

Hose it is necessary to press at distance about 5 cm from a cut of the cylinder of the end tense on the union. Disconnect a hose from the tank, turn out a fixing bolt and take tank assembly from an impellent compartment.

4. Release a fixing collar and disconnect from the main cylinder the hydraulic line. For the purpose of minimization of losses of hydraulic liquid wind shtutserny knot with rags. At once закупорьте the open ends of the line and the union in order to avoid hit in dirt system.

In order to avoid damage of a paint and varnish covering, do not allow hit of hydraulic liquid on the painted surfaces of body panels.

5. Remove established in a wheel arch the power relay with the arm.

6. In car salon under the dashboard give two nuts of fastening of the main cylinder to a partition of an impellent compartment. Remove the cylinder from the car.

INSTALLATION

 PERFORMANCE ORDER

1. Get the main cylinder on the regular place and fix it bolts, having by hand tightened nuts of the last.
2. Restore initial connection of hydraulic lines. Tighten fixing collars.
3. Strongly tighten fixture and the union of the hydraulic line. Tighten nuts of fastening of the cylinder with demanded effort.
4. Connect a cylinder pusher to a pedal of coupling and fix a new pin a cutting finger.
5. Establish on the regular place the power relay with an arm.
6. Remove the nippers pressing submitting hose. Fill in in the tank necessary amount of brake DOT 3 liquid, then give from a path air jams (see. The section air Removal from a hydraulic path of a drive of switching off of coupling).