Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
- Coupling and power shafts
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Coupling and power shafts

Specifications

General parameters

Coupling type
Dry one-disk, with a diafragmenny press spring
Pedal height at switching off of coupling, mm 76 ÷ 89
Free wheeling of a pedal of coupling, mm 9.5 ÷ 16
Standard height of a pedal of coupling, mm 190.5
Course of a pedal of coupling, mm 146
Power shafts
Length of power shafts, mm
4-cylinder models
Models with RKPP
Left shaft 518.3 ÷ 523.1
Right shaft 497.7 ÷ 503.2
Models with AT
Left shaft 868.4 ÷ 873.9
Right shaft 497.7 ÷ 503.2
 
Left shaft 531.0 ÷ 535.8
Right shaft 541.3 ÷ 546.1
Efforts of a tightening of carving connections N • m
Nuts of fastening of the main cylinder of coupling 12.4
Bolts of fastening of the executive cylinder of coupling 23
Bolts of fastening of a basket of coupling 26
Stupichnye of a nut 243
Bolts of fastening of the basic holder
bearing of an intermediate shaft
39

The present Head is devoted to the components located between a back part of the engine and driving wheels of the car (without a transmission which is considered in Head a gear shifting Box). According to the destination considered components can be broken into two categories: coupling and power shafts. Descriptions of a design and a principle of action of each of separate knots, and also procedures of check of a condition, removal, dismantling and regenerative repair of components entering into both groups are provided in below-mentioned Sections.

As the most part of procedures described in the present Chapter is made under the car, it is necessary to give special attention to reliability of fixing of the last in the lifted situation.