Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
- Engine electric equipment
   General information and precautionary measures
   Engine start from the auxiliary power supply
   Check of a condition and battery replacement
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information
   Check of functioning of system of ignition
   Check of a condition and replacement of the coil of ignition
   Check of serviceability of functioning and replacement of the module of management with ignition (ICM)
   Removal and installation of the distributor of ignition
   Check of installation of a corner of an advancing of ignition
   Charge system - the general information and precautionary measures
   Check of a condition of system of a charge
   Removal and generator installation
   Replacement of a regulator of tension and generator brushes
   Start system - the general information and precautionary measures
   Check of serviceability of functioning of a starter on the car (in situ)
   Removal and starter installation
   Removal and installation of the traction relay
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Check of a condition and replacement of the coil of ignition

4-cylinder models

CHECK

 PERFORMANCE ORDER

1. Switch off ignition (the key should be turned in the situation OFF).
2. Remove from the distributor a cover, a begunok and the filter.
3. Disunite electric sockets of primary contour of the coil of ignition.
4. By means of an ohmmeter measure resistance between plugs (And and In) primary winding of the coil. Compare result of measurement to requirements of Specifications.

5. Then measure resistance between the positive plug of primary winding (And) and the plug of a secondary winding. Again compare result to requirements of Specifications.

6. Remember that standard values of resistance of windings change with temperature. Nominal rates, characteristic coils 21°С are specified in Specifications for temperature.
7. If in any of the last two checks the result of measurement falls outside the limits an admissible range, replace the ignition coil.

REPLACEMENT

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Remove from the distributor a cover and the filter (at the corresponding complete set) (see. Head of Control and routine maintenance). Disconnect wires from plugs of primary contour of the coil.

3. Turn out two fixing screws and take the ignition coil from distributor assembly.

4. Installation is made upside-down.

4-cylinder models

CHECK

 PERFORMANCE ORDER

1. Switch off ignition (the key should be turned in the situation OFF).
2. Disconnect VV a wire from the plug of a secondary winding (bobbin).
3. Remove the 3-contact socket from primary plugs of the coil of ignition.

4. By means of an ohmmeter measure resistance between plugs (1 and 3 primary windings of the coil. Compare result of measurement to requirements of Specifications.

5. Connect an ohmmeter between the average plug (2) and the plug of a secondary winding. Compare result of measurement to requirements of Specifications.
6. Remember that standard values of resistance of windings change with temperature. Nominal rates, characteristic coils 21°С are specified in Specifications for temperature.
7. If in any of the last two checks the result of measurement falls outside the limits an admissible range, replace the ignition coil.

REPLACEMENT

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Disconnect from the ignition coil electroconducting.

3. Turn out fixing bolts and remove the ignition coil.

4. Installation is made upside-down.