Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
- Engine electric equipment
   General information and precautionary measures
   Engine start from the auxiliary power supply
   Check of a condition and battery replacement
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information
   Check of functioning of system of ignition
   Check of a condition and replacement of the coil of ignition
   Check of serviceability of functioning and replacement of the module of management with ignition (ICM)
   Removal and installation of the distributor of ignition
   Check of installation of a corner of an advancing of ignition
   Charge system - the general information and precautionary measures
   Check of a condition of system of a charge
   Removal and generator installation
   Replacement of a regulator of tension and generator brushes
   Start system - the general information and precautionary measures
   Check of serviceability of functioning of a starter on the car (in situ)
   Removal and starter installation
   Removal and installation of the traction relay
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal and installation of the traction relay

 PERFORMANCE ORDER

On 4-cylinder models from RKPP the starter of manufacturing of the Nippondenso company with the fixed traction relay is used. In case of the last out of operation all assembly is subject to replacement. The description provided below belongs to the starters of Mitsuba applied on the V6 models.

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Remove a starter (see. Section Removal and starter installation).
3. Disconnect the big wire connecting the traction relay to the plug of the electromotor of a starter.

4. Turn out long bolts of fastening of a face cover to a reducer casing. Remove the case of anchor assembly.

5. Turn out fixing screws and separate a reducer casing from a forward cover of assembly.

6. Turn out fixing screws from a casing of a reducer and remove the traction relay.

7. Installation is made upside-down. Before assembly grease the lever of a drive and a plunzher of the traction relay with assembly greasing.