Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
- Engine electric equipment
   General information and precautionary measures
   Engine start from the auxiliary power supply
   Check of a condition and battery replacement
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information
   Check of functioning of system of ignition
   Check of a condition and replacement of the coil of ignition
   Check of serviceability of functioning and replacement of the module of management with ignition (ICM)
   Removal and installation of the distributor of ignition
   Check of installation of a corner of an advancing of ignition
   Charge system - the general information and precautionary measures
   Check of a condition of system of a charge
   Removal and generator installation
   Replacement of a regulator of tension and generator brushes
   Start system - the general information and precautionary measures
   Check of serviceability of functioning of a starter on the car (in situ)
   Removal and starter installation
   Removal and installation of the traction relay
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Replacement of a regulator of tension and generator brushes

In the present Section the procedure description measurements of brushes and a tension regulator on the Nippondenso generators established on 4-cylinder models is provided. Regulator replacement on the V6 models is made complete with the production Mitsubishi/Delphi generator.


Remove the generator from the car (see. The section Removal and generator installation) also transfer it on a workbench.

Brushes

 PERFORMANCE ORDER

1. Give three fixing nuts and remove a back cover of the generator, also give a fixing nut and remove a terminal insulator.

2. Turn out two screws of fastening of a shchetkoderzhatel.

3. Remove a shchetkoderzhatel from a back end face of the generator.

4. Measure length of a vystupaniye of each of brushes from the boss in the holder and compare results of measurements to requirements of Specifications. If the size of a vystupaniye of brushes falls outside the limits the bottom border of an admissible range, make their replacement.

5. Check freedom of a course of brushes in cartridges of the holder.
6. At installation of a shchetkoderzhatel into place wring out brushes a small screw-driver for a shaft transmission.
7. Screw and tighten fixing screws.
8. Establish into place a back cover and strongly tighten three fixing nuts.
9. Establish into place a terminal insulator and tighten a nut of its fastening.
10. Establish the generator on the regular place (see. Section Removal and generator installation).

Tension regulator

 PERFORMANCE ORDER

1. Execute the procedures described above in paragraphs with 1 on 3. Turn out screws of fastening of a regulator to a back frame of assembly of the generator.

2. Remove a regulator from generator assembly.
3. Installation is made upside-down.