Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
- Power supply system and release
   Sbrasyvaniye of pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a condition and replacement of fuel lines
   Removal and installation of the fuel pump
   Check of a condition and sensor replacement
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of assembly of an air purifier
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Removal and installation of the case of a throttle
   Removal and installation of a regulator of pressure of fuel
   Removal and installation of the fuel highway and fuel injectors
   Release system - the general information
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Check of a condition and sensor replacement

 PERFORMANCE ORDER

See preventions at the beginning of pressure Sbrasyvaniye's Section in a power supply system.

1. Disconnect a negative wire from the battery.

сли the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Take from a tank gasoline pump assembly with the fuel consumption sensor (see. Section Removal and installation of the fuel pump).

3. By means of an ohmmeter measure resistance between plugs of the socket of assembly.

It is necessary to choose a range of measurement of an ohmmeter in 200 Ohm. Write down measuring instrument indications in two extreme provisions of a float of assembly of the sensor of fuel consumption. Resistance change should occur to moving of a float evenly, without breakthroughs and delays.

4. At an empty tank (the bottom provision of a float) resistance of the sensor should make 105 ÷ 107 Ohm.
5. In the top provision of a float of the indication of an ohmmeter should make 3 ÷ 5 Ohm.
6. At negative results described above check replace the fuel consumption sensor.

REPLACEMENT

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Take from a tank assembly of the gasoline pump/sensor of fuel consumption (see. Section Removal and installation of the fuel pump).

3. Disconnect electroconducting of the block of the sensor of fuel consumption from the assembly basis.

4. Turn out fixing screws and separate the fuel consumption sensor from a basic arm of assembly of a gasoline pump.

5. Installation is made upside-down. Do not forget to replace the sealing laying established under a landing flange of assembly.