Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
- Power supply system and release
   Sbrasyvaniye of pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a condition and replacement of fuel lines
   Removal and installation of the fuel pump
   Check of a condition and sensor replacement
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of assembly of an air purifier
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Removal and installation of the case of a throttle
   Removal and installation of a regulator of pressure of fuel
   Removal and installation of the fuel highway and fuel injectors
   Release system - the general information
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal and installation of the fuel pump

 PERFORMANCE ORDER

See preventions at the beginning of pressure Sbrasyvaniye's Section in a power supply system.

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Dump pressure in a power supply system (see. Undressed Sbrasyvaniye pressure in a power supply system).
3. Lift a floor carpet in a luggage compartment of the car.

4. Turn out bolts of fastening of a cover of access to a fuel tank.

5. Disconnect from assembly electroconducting. Having released clamps of sockets of fast joining, disconnect fuel lines.

6. Give nuts of fastening of pump assembly.

7. Accurately take assembly from a fuel tank.
8. Disconnect electroconducting of assembly of the fuel pump.

9. Nippers compress clips of fastening of a fuel hose, - remove the top clip, bottom shift to the hose middle, having completely released the pump union.

10. Remove from the bottom end face of assembly filtering element of a toplivozabornik.

11. Separate the pump from a basic arm.
12. Installation is made upside-down. Do not forget to replace sealing laying of a landing flange of assembly.