Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
- Power supply system and release
   Sbrasyvaniye of pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a condition and replacement of fuel lines
   Removal and installation of the fuel pump
   Check of a condition and sensor replacement
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of assembly of an air purifier
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Removal and installation of the case of a throttle
   Removal and installation of a regulator of pressure of fuel
   Removal and installation of the fuel highway and fuel injectors
   Release system - the general information
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal and installation of a regulator of pressure of fuel

 PERFORMANCE ORDER

See preventions at the beginning of pressure Sbrasyvaniye's Section in a power supply system.

1. Dump pressure in a power supply system (see. Undressed Sbrasyvaniye pressure in a power supply system).
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for equipment input in action!

3. On the V6 models remove access covers from the top part of the power unit (see. Head Engine).
4. Disconnect from a pressure regulator vacuum and fuel hoses.

5. Remove a pressure regulator from assembly of the fuel highway:
a) On 4-cylinder engines the regulator fastens to the highway fixing bolts;

b) On V6 engines the reversing of a regulator will need a rozhkovy key.

6. Installation is made upside-down. Do not forget to replace a sealing ring which before installation it is necessary to grease with pure impellent oil slightly. A tightening of fixture/assembly of a regulator make with demanded effort.
7. Check the engine on existence of signs of leakages of fuel.