Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
- Power supply system and release
   Sbrasyvaniye of pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a condition and replacement of fuel lines
   Removal and installation of the fuel pump
   Check of a condition and sensor replacement
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of assembly of an air purifier
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Removal and installation of the case of a throttle
   Removal and installation of a regulator of pressure of fuel
   Removal and installation of the fuel highway and fuel injectors
   Release system - the general information
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal and installation of the case of a throttle

 PERFORMANCE ORDER

Before starting performance of procedures wait complete cooling of the engine!

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for equipment introduction in action!

2. Remove the air sleeve connecting an air purifier to the case of a throttle.
3. Disconnect electroconducting of the sensor of provision of a butterfly valve (TPS) from the throttle case (see. Head Engine management). Mark and disconnect from the throttle case vacuum hoses.
4. Disconnect from the butterfly valve lever an accelerator cable (see. The section Removal, installation and adjustment of a cable of an accelerator) and (at the corresponding complete set of the car) a cable of a drive of a butterfly valve in the kick-down mode.
5. Disconnect from the throttle case hoses of an okhladitelny path. At once закупорьте the open ends of hoses for the purpose of minimization of losses of cooling liquid.
6. Release 4 fixing nuts, separate the throttle case from the inlet pipeline and remove sealing laying. Carefully scratch out traces of old laying from interfaced surfaces of the case of a throttle and the delivery chamber of an air path.

7. Installation is made upside-down. Do not forget to replace sealing laying. Fixture of the case of a throttle tighten with demanded effort. In summary make adjustment of a cable of an accelerator (see. Section Removal, installation and adjustment of a cable of an accelerator). Check level of cooling liquid, in case of need make the corresponding adjustment (see. Head of Control and routine maintenance).