Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
- Systems of cooling, heating
   Antifreeze - general information
   Check of serviceability of functioning and thermostat replacement
   Check of a condition of fans of system of cooling and chains of their inclusion, replacement of fans
   Removal and installation of a radiator and broad tank of system of cooling
   Check of a condition of the water pump
   Replacement of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of a measuring instrument of temperature of cooling liquid
   Check of serviceability of functioning of the driving electromotor of the fan of a heater and condition of components of its electric chain, replacement of components
   Removal and installation of the electromotor of a drive of the fan of a heater
   Removal and installation of assembly of the control panel by functioning of a heater and air conditioner, adjustment of a driving cable
   Removal and installation of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Check of an electric chain of the coupling of coupling of the To/in compressor
   Removal and receiver dehumidifier installation To/in
   Removal and To/in compressor installation
   Removal and To/in condenser installation
   Removal and To/in evaporator installation with the broad valve
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal and installation of the electromotor of a drive of the fan of a heater

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

сли the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Assembly of the fan of a heater is located under the car dashboard, behind a ware box, near a partition of an impellent compartment. The structure of assembly includes the driving electromotor, rezistorny knot and the motor of inclusion of a mode of the closed circulation.

3. Disunite the socket of electroconducting of the driving electromotor and turn out three fixing screws. Remove the motor.

4. If the motor is subject to replacement, disconnect it from a krylchatka of the fan, - use nippers for an otpuskaniye and clamp removal. Rearrange a krylchatka on assembly of the new electromotor.

5. Installation is made upside-down. Check serviceability of functioning of the fan.