Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
- Systems of cooling, heating
   Antifreeze - general information
   Check of serviceability of functioning and thermostat replacement
   Check of a condition of fans of system of cooling and chains of their inclusion, replacement of fans
   Removal and installation of a radiator and broad tank of system of cooling
   Check of a condition of the water pump
   Replacement of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of a measuring instrument of temperature of cooling liquid
   Check of serviceability of functioning of the driving electromotor of the fan of a heater and condition of components of its electric chain, replacement of components
   Removal and installation of the electromotor of a drive of the fan of a heater
   Removal and installation of assembly of the control panel by functioning of a heater and air conditioner, adjustment of a driving cable
   Removal and installation of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Check of an electric chain of the coupling of coupling of the To/in compressor
   Removal and receiver dehumidifier installation To/in
   Removal and To/in compressor installation
   Removal and To/in condenser installation
   Removal and To/in evaporator installation with the broad valve
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Check of a condition of the water pump

Failure of the water pump is capable to cause the most serious consequences, up to complete jamming of the engine as a result of an overheat.

There are two ways of check of serviceability of functioning of the water pump without its removal from the engine. The defective pump without fail is subject to replacement. As the replaceable it can be used both new, and the restored assembly.

The water pump is equipped control (or ventilating) with openings. In case of epiploon failure from openings cooling liquid starts to exude. Prepare a pocket small lamp and a small pocket mirror, then uncover a belt of a drive of GRM. By means of a lamp and a mirror find control openings from below on the back/lower part of the pump and check, whether cooling liquid exudes through them.

At failure of bearings of a shaft of the pump in engine operating time in its forward part there can be a howling sound which should not be confused to the whistle published by a driving belt at weakening of effort of its tension. Wear of the bearing can be revealed on existence люфта when rocking a pulley of the pump (do not forget to switch off before the engine).

Sometimes wear of the pump in any way outwardly is not shown, therefore during carrying out major maintenance of the engine it is meaningful to disassemble assembly and visually to estimate a condition of its internal components. Often efficiency of functioning of the pump decreases owing to strong damage by corrosion of rotor shovels.