Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
- Systems of cooling, heating
   Antifreeze - general information
   Check of serviceability of functioning and thermostat replacement
   Check of a condition of fans of system of cooling and chains of their inclusion, replacement of fans
   Removal and installation of a radiator and broad tank of system of cooling
   Check of a condition of the water pump
   Replacement of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of a measuring instrument of temperature of cooling liquid
   Check of serviceability of functioning of the driving electromotor of the fan of a heater and condition of components of its electric chain, replacement of components
   Removal and installation of the electromotor of a drive of the fan of a heater
   Removal and installation of assembly of the control panel by functioning of a heater and air conditioner, adjustment of a driving cable
   Removal and installation of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Check of an electric chain of the coupling of coupling of the To/in compressor
   Removal and receiver dehumidifier installation To/in
   Removal and To/in compressor installation
   Removal and To/in condenser installation
   Removal and To/in evaporator installation with the broad valve
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal and To/in evaporator installation with the broad valve

Air central air constantly is under a high pressure. At all do not disconnect refrigerator lines and do not remove any components of system, previously without having executed a discharge of the last. The discharge of central air of air should be made by strengths of the skilled expert in the conditions of a car-care center workshop. At a rassoyedineniye of refrigerator lines surely put on goggles!

At replacement of components of central air of air the certain amount of replaceable refrigerator oil necessary for filling of volume of new knot is required. Use only the oil good for the use in R-134a systems (attentively study a label on the container).

REMOVAL

 PERFORMANCE ORDER

1. Make a discharge of central air of air in the conditions of a specialized workshop.
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

3. Turn out bolts and disconnect from the evaporator two refrigerator lines.

4. At once закупорьте the open ends of lines and unions in order to avoid hit in dirt system.
5. Remove the passenger knee emphasis, the metal bar located under it and a ware box with the frame (see. Head Body).
6. Disconnect electroconducting from the thermostat.

7. Release clamps of fastening of a casing of the evaporator to a partition of an impellent compartment and the dashboard.

8. Disconnect a drain hose and remove evaporator assembly from the car.
9. Remove from the evaporator the thermosensitive sensor.
10. Remove air filters with pallets (see. Head of Control and routine maintenance), then turn out screws, divide a casing into two half and liberate from it the evaporator. In case of need remove the broad valve.

INSTALLATION

 PERFORMANCE ORDER

1. Installation is made upside-down. Do not forget to replace sealing rings of shtutserny connections, - before installation grease new rings with refrigerator R-134a oil. An adhesive tape примотайте a capillary tube of the broad valve to the soaking-up line also establish on the regular place the thermosensitive sensor.

2. Make a charging of system and its check on leaks in the conditions of a specialized workshop. At replacement of the evaporator add in system about 40 ml of refrigerator oil.