Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
- Engine
   + Four-cylinder engines
   - V6 engines
      Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Removal and installation of covers of heads of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of final collectors
      Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
      Replacement of a forward epiploon of a cranked shaft
      VTEC system - the general information
      Removal, check of a condition and installation of assembly of yokes
      Removal, check of a condition and installation of camshafts
      Replacement of maslootrazhatelny caps and klapanny springs with plates
      Removal and installation of heads of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation of a driving disk
      Replacement of a back epiploon of a cranked shaft
      Check of a condition and replacement of support of a suspension bracket of the power unit (V6 Engines)
      System of correction of a suspension bracket of the power unit - the general information and check of serviceability of functioning
   + General and major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Replacement of a forward epiploon of a cranked shaft

 PERFORMANCE ORDER

1. Remove a gas-distributing belt and a cogwheel of a cranked shaft (see. Section Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM).

2. Having accurately hooked the special tool or a big screw-driver, take an old epiploon from the landing nest. Try not to leave scratches and задиров on a surface of a pin of a shaft or walls of a landing nest, - existence of similar defects will lead to fast failure of a new epiploon.

3. Clear internal surfaces of a landing nest. Slightly grease external edge of a new epiploon with pure impellent oil, in sponges of an epiploon fill universal greasing.

4. Having used as an opravka a face head of the corresponding size, or a piece of a pipe of suitable diameter, plant a new epiploon in the nest (the opravka should rest only against the firm external region of a face surface of an epiploon) on the same depth on which the old was drowned. Having planted an epiploon, make sure that the rasporny spring did not jump out of the flute.

5. Establish into place a cogwheel of a cranked shaft and a gas-distributing belt (see. Section Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM).
6. Start the engine and check it on existence of signs of leakages of oil around landing of a forward epiploon.