Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
- Engine
   + Four-cylinder engines
   - V6 engines
      Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Removal and installation of covers of heads of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of final collectors
      Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
      Replacement of a forward epiploon of a cranked shaft
      VTEC system - the general information
      Removal, check of a condition and installation of assembly of yokes
      Removal, check of a condition and installation of camshafts
      Replacement of maslootrazhatelny caps and klapanny springs with plates
      Removal and installation of heads of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation of a driving disk
      Replacement of a back epiploon of a cranked shaft
      Check of a condition and replacement of support of a suspension bracket of the power unit (V6 Engines)
      System of correction of a suspension bracket of the power unit - the general information and check of serviceability of functioning
   + General and major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal and installation of covers of heads of cylinders

REMOVAL

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Disconnect from spark plugs of VV of a wire, remove basic arms and shift them aside. Disconnect electroconducting from the sensor of temperature of the oil located from above on a cover of a back head of cylinders, is closer to a gas-distributing belt.
3. Remove the top inlet pipeline (see. Section Removal and installation of the inlet pipeline).
4. In the left part of a cover of a back head disconnect a hose of PCV and turn out a bolt of fastening of a basic arm of a hose of the steering pump. Shift a hose aside.
5. Disconnect a ventilating hose from the left wall of a cover of a back head of cylinders. Take a hose aside.

6. Turn out fixing bolts and uncover heads of cylinders. If the cover "became attached" and does not give in to separation from a head, is accurate обстучите its hammer through a wooden pro-rate.

At all do not make attempts of office of a cover by a podrychazhivaniye it for an interfaced surface, - any mechanical damages of the last are capable to lead to development of leaks.

7. Remove old laying and sealing washers, then carefully smooth out interfaced surfaces of a head and a cover. Make sure of serviceability of a condition of the PCV valve (see. Head of Control and routine maintenance) also return it on the regular place on a head cover.

INSTALLATION

 PERFORMANCE ORDER

1. Lay new sealing laying in the landing flute, put on fixing bolts sealing washers.
2. Establish a cover on a head of cylinders, screw fixing bolts and tighten them in three stages with demanded effort.

Before installation it will be reasonable to grease sealing washers and places of their contact to a cover and a head with soap solution slightly.

3. Installation of the remained components is made as it should be, the return to an order of their dismantle.