Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
- Engine
   + Four-cylinder engines
   - V6 engines
      Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Removal and installation of covers of heads of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of final collectors
      Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
      Replacement of a forward epiploon of a cranked shaft
      VTEC system - the general information
      Removal, check of a condition and installation of assembly of yokes
      Removal, check of a condition and installation of camshafts
      Replacement of maslootrazhatelny caps and klapanny springs with plates
      Removal and installation of heads of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation of a driving disk
      Replacement of a back epiploon of a cranked shaft
      Check of a condition and replacement of support of a suspension bracket of the power unit (V6 Engines)
      System of correction of a suspension bracket of the power unit - the general information and check of serviceability of functioning
   + General and major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Replacement of a back epiploon of a cranked shaft

 PERFORMANCE ORDER

1. Remove transmission (see. Head gear shifting Box) and driving disk.

The engine should be hung out from above by means of the winch or And-shaped......

2. Replacement of an epiploon can be made without preliminary dismantle of the pallet of a case and the holder of an epiploon, however it is necessary to remember that the new epiploon has rather rigid sponges which can easily appear are damaged at installation the probability of a reversing of an epiploon, besides, is rather high at its landing in a nest. The description of the special precautionary measures is provided in the Part the General and major maintenance of the engine of the present Chapter, allowing to avoid this sort of troubles, however, all of them demand preliminary dismantle of the pallet of a case and a plate of the holder. Wishing to risk, try to make replacement of an epiploon of in situ, - take old of a landing nest in the holder by a poddevaniye its screw-driver.

3. Slightly grease edges of a pin and a sponge of a new epiploon with universal greasing, then, helping itself a blunt tool, put on an epiploon a shaft. By means of an opravka and a hammer plant an epiploon in a nest (A rasporny spring inside). Quality of an opravka when landing an epiploon the face head of the corresponding size, or a piece of a pipe of suitable diameter (slightly less external diameter of an epiploon) can be used.

The epiploon should be planted aflush with a surface of the holder.

4. Further installation is made as it should be, the return to an order of dismantle of components.