Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
- Engine
   + Four-cylinder engines
   - V6 engines
      Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Removal and installation of covers of heads of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of final collectors
      Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
      Replacement of a forward epiploon of a cranked shaft
      VTEC system - the general information
      Removal, check of a condition and installation of assembly of yokes
      Removal, check of a condition and installation of camshafts
      Replacement of maslootrazhatelny caps and klapanny springs with plates
      Removal and installation of heads of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation of a driving disk
      Replacement of a back epiploon of a cranked shaft
      Check of a condition and replacement of support of a suspension bracket of the power unit (V6 Engines)
      System of correction of a suspension bracket of the power unit - the general information and check of serviceability of functioning
   + General and major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal and installation of a driving disk

 PERFORMANCE ORDER

1. Remove transmission (see. Head gear shifting Box).

The engine should be hung out from above on the winch or And-shaped......

2. Turn out bolts of fastening of a driving disk to a cranked shaft.
3. Carefully wipe the removed disk the rags moistened in acetone, having completely removed from it oil and greasing traces. Check a working surface of a disk on existence of cracks and other mechanical damages. Minor defects can be eliminated by means of a fine-grained emery paper. Check a gear wreath on existence of cracks and chips of teeths. Lay a disk on a flat surface for the purpose of an assessment of its planeness (use a planeness measuring instrument). In case of need give assembly to a pro-point.
4. Wipe interfaced surfaces of a driving disk and a cranked shaft. If signs of leakages of oil through a back epiploon of a cranked shaft take place, make its replacement (see. Section Replacement of a back epiploon of a cranked shaft).
5. Establish a driving disk on a cranked shaft.

Fixing openings are located asymmetrically that guarantees unambiguity of landing of assembly. Before rolling fixing bolts, grease their carving part with fixing hermetic.

6. Tighten fixing bolts with demanded effort in strictly certain order.

7. Further installation is made as it should be, the return to an order of dismantle of components.