Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
- Engine
   + Four-cylinder engines
   - V6 engines
      Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Removal and installation of covers of heads of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of final collectors
      Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
      Replacement of a forward epiploon of a cranked shaft
      VTEC system - the general information
      Removal, check of a condition and installation of assembly of yokes
      Removal, check of a condition and installation of camshafts
      Replacement of maslootrazhatelny caps and klapanny springs with plates
      Removal and installation of heads of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and installation of a driving disk
      Replacement of a back epiploon of a cranked shaft
      Check of a condition and replacement of support of a suspension bracket of the power unit (V6 Engines)
      System of correction of a suspension bracket of the power unit - the general information and check of serviceability of functioning
   + General and major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car

Make cleaning of an impellent compartment and external surfaces of the power unit with application of one of a wide range of special solvents. Such processing will allow to avoid dirt hit in the engine.

In case of need, the forthcoming work defined by character, it is possible to remove a cowl for the purpose of ensuring freedom of access to components subject to service (see. Head Body). Cover car wings with special covers, or simply old blankets in order to avoid casual damage of a paint and varnish covering.

If existence of suspicions on losses of depression or the leakage of oil cooling liquids, the fulfilled gases, etc. indicates need of performance of replacement of the corresponding laying or epiploons, practically any of the listed procedures can be executed without engine extraction from the car (in situ). Told concerns procedures of replacement of laying of the inlet pipeline and a final collector, the pallet of a case, heads of cylinders, and also both epiploons of a cranked shaft.

Dismantle, repair and installation of such external knots and hinged units, as the inlet pipeline, a final collector, the case pallet, the water pump (see. The head of System of cooling, heating), a starter, the generator, the ignition distributor (see. Head engine Electric equipment) and power supply system components (see. Head of the Power supply system and release) in situ also can be made.

As heads of cylinders can be removed from the engine without preliminary extraction of the power unit, repair of the klapanny mechanism also can be made directly on the car. Besides, in situ is usually made replacement of camshafts, a gas-distributing belt and cogwheels of a drive of GRM.

In an emergency without dismantle of the power unit performance of repair and replacement of piston rings, pistons, rods and shatunny bearings of a cranked shaft is allowed also. However it is not necessary to abuse such possibility in view of the difficulties connected with need of observance of purity and carrying out a number of preparatory procedures.