Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
- Engine
   - Four-cylinder engines
      Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Removal and installation of a cover of a head of cylinders
      VTEC system - the general information and check of a condition of components
      Removal, check of a condition and installation of assembly of yokes
      Replacement of maslootrazhatelny caps and klapanny springs with plates
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      Removal, check of a condition and installation of cogwheels and belt of a drive of balancing shaft
      Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
      Replacement of a forward epiploon of a cranked shaft
      Removal, check of a condition and camshaft installation
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and flywheel installation / driving disk
      Replacement of a back epiploon of a cranked shaft
      Check of a condition and replacement of support of a suspension bracket of the power unit
      System of correction of a suspension bracket of the power unit - the general information and check of serviceability of functioning
   + V6 Engines
   + General and major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Replacement of a forward epiploon of a cranked shaft

 PERFORMANCE ORDER

1. Remove driving belts (see. Head of Control and routine maintenance).
2. Remove a gas-distributing belt and a belt of a drive of balancing shaft (see. Sections Removal, check of a condition and installation of assembly of yokes and Removal, check of a condition and installation of camshafts).
3. Remove a pulley of a cranked shaft (see. Section Removal, check of a condition and installation of assembly of yokes).
4. Disconnect electroconducting from the sensor of provision of cranked shaft/VMT (sensor SKR/VMT) (the socket of the main plait of electroconducting). Turn out fixing bolts and remove sensor assembly from the case of the oil pump.

5. Remove a cogwheel of a cranked shaft and the concave washer established under it.

6. Having accurately hooked the special tool or a big screw-driver, take an old epiploon from the landing nest in a casing of the oil pump. Try not to leave scratches and задиров on a surface of a pin of a shaft or the pump case, - existence of similar defects will lead to fast failure of a new epiploon.
7. Clear internal surfaces of a nest under epiploon landing. Grease external edge of a new epiploon with pure impellent oil, or universal greasing. Having used as an opravka a face head of the corresponding size, or a piece of a pipe of suitable diameter, plant a new epiploon in the nest (the opravka should rest only against the firm external region of a face surface of an epiploon). Having planted an epiploon, make sure that the rasporny spring did not jump out of the flute.
8. Plant on a pin of a cranked shaft a concave washer, then establish a cogwheel.
9. Further installation is made as it should be, the return to an order of dismantle of components.
10. Start the engine and check it on existence of signs of leakages of oil.