Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
- Gear shifting box
   + 5-step manual box of gear shifting (RKPP)
   - 4-step automatic transmission (AT)
      Problem diagnostics AT/CVT - the general information
      Removal, installation and adjustment of a cable of gear shifting
      Removal and installation of the lever of switching (selector) of transfers
      Blocking system - the general information, condition check, replacement and adjustment of an electromagnet of management
      Adjustment and replacement of the sensor switch of provision of transmission
      Check and replacement of electromagnetic valves of management with transmission functioning
      Removal and installation of 4-step and automatic transmission (AT)
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Adjustment and replacement of the sensor switch of provision of transmission

CHECK

 PERFORMANCE ORDER

1. Access to the socket of electroconducting of the sensor switch is possible from an impellent compartment.

2. Disunite the 10-contact socket of the sensor switch of provision of transmission.

3. Check the socket on compliance of conditions of the sensor switch to the conductivity card. Transfer the selector lever serially to each of provisions.

4. At negative results of check make sensor switch adjustment. If to adjust the sensor switch it is not possible, replace it.

ADJUSTMENT

 PERFORMANCE ORDER

1. Transfer the selector lever to the situation "N" and weaken nuts of fastening of the sensor switch.

2. Disunite the 10-contact socket and connect an ohmmeter to plugs 1 and 3.

3. Uncover and slightly weaken bolts of fastening of the sensor switch. Turn the sensor switch in the situation "N", - click should be distributed, and the ohmmeter will fix emergence of conductivity.
4. Tighten fixing bolts, establish into place a cover and connect the socket.

REPLACEMENT

 PERFORMANCE ORDER

1. To Poddomkratta the car also establish it on props.

2. Disunite the 10-kontatkny socket. Turn out a bolt of the holder of a plait of electroconducting.

3. Transfer the selector lever to the situation "N".
4. Uncover the situation AT sensor switch, then turn out bolts of fastening of the sensor switch.

5. Transfer the new sensor switch to the situation corresponding to the situation "N", make sure that the selector lever also is in the situation "N".

6. Put on the sensor switch an axis of management and, having tracked, that it remained in the situation "N", tighten fixing bolts.

7. Connect electroconducting, fix a plait and establish into place a cover.
8. Make sure that the engine is started only in the positions "N" and "R" of the lever of the selector.