Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
- Gear shifting box
   - 5-step manual box of gear shifting (RKPP)
      Replacement of epiploons of power shafts
      Removal and installation of a drive and gear shifting lever
      Check and replacement of the sensor switch of fires of a backing
      Removal and RKPP installation
      Major maintenance of RKPP - the general information
   + 4-step automatic transmission (AT)
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal and installation of a drive and gear shifting lever

Models of cars considered in the real Management are equipped with system of additional safety (SRS). Before starting performance of any works near the block of a safety cushion, a steering column or the dashboard, disconnect SRS in order to avoid receiving traumas at its casual operation (see. Head Onboard electric equipment). Electroconducting of a chain of SRS is easy for distinguishing on yellow color of isolation.

Cables of a drive of gear shifting

 PERFORMANCE ORDER

Even in case of break only one of driving cables, their replacement is made in a complete set (in an individual order cables of a drive of a choice and gear shifting are not delivered).

1. Unscrew the plastic handle and remove it from the gear shifting lever.
2. Remove console assembly (see. Head Body).

3. Take шплинт, remove a washer and disconnect a driving cable from draft of switching, then give самоконтрящуюся a nut and disconnect the second cable from the basis of the lever of gear shifting.

4. Take lock washers and liberate cables from an assembly bracket of the lever of gear shifting.

5. Open a cowl and find the forward ends of driving cables). Disconnect cables from executive levers of a choice and gear shifting (the first is located from above on a cover of the mechanism of the switching, the second - assembly). Take lock washers and liberate cables from basic arms.

6. Walk on cables back to a partition of an impellent compartment and liberate from the last plugs through passage.
7. Extend cables outside.
8. Installation is made upside-down. At connection of the forward ends of cables track, that the plastic washer was established between a tip of a cable and a steel washer (a cable of a choice of transfers) and between a steel washer and shplinty (a gear shifting cable).

Gear shifting lever

 PERFORMANCE ORDER

1. Turn on and remove from the gear shifting lever the plastic handle.
2. Remove console assembly (see. Head Body).
3. Disconnect from the lever basis choice and gear shifting cables (see above paragraphs with 1 on 7).

4. Turn out bolts of fastening of an assembly bracket of the basis of the lever.

5. Remove assembly of the lever of switching.
6. Installation is made upside-down.