Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Search of causes of failures of electric equipment
   Safety locks - the general information
   Chain breakers
   The relay - the general information and check of serviceability of functioning
   Check of serviceability of functioning and replacement of the breaker of indexes of turns / alarm system
   Check of serviceability of functioning and replacement of podrulevy switches
   Check of serviceability of functioning and replacement of the switch of ignition and lock of blocking of a steering column
   Check of serviceability of functioning and replacement of switches of the dashboard
   Check of serviceability of functioning of measuring instruments of a combination of devices
   Removal and installation of a combination of devices
   Removal and installation of a radio receiver and loudspeakers
   Removal and installation of the aerial of a radio receiver
   Replacement of lamps of head headlights
   Adjustment of the direction of optical axes of head headlights
   Replacement of block headlights
   Replacement of lamps
   Running fires of light time of day (DRL)
   Check of serviceability of functioning and replacement of the electromotor of a drive of screen wipers
   Check of serviceability of functioning and replacement of horns of a horn
   Check of serviceability of functioning and regenerative repair of a heater of back glass
   Control system of speed (темпостат) - general information and check of serviceability of functioning
   The electric drive of window regulators - general information and check of serviceability of functioning
   The uniform lock - general information and check of serviceability of functioning
   The electric drive of external rear-view mirrors - general information and check of serviceability of functioning
   Safety cushions - the general information
+ electric equipment Schemes





Check of serviceability of functioning and replacement of podrulevy switches

Models of cars considered in the real Management are equipped with system of additional safety (SRS). Before starting performance of any works near the block of a safety cushion, a steering column or the dashboard, disconnect SRS in order to avoid receiving traumas at its casual operation (see. The Safety cushion section - the general information). Electroconducting of a chain of SRS is easy for distinguishing on yellow color of isolation.

Combined podrulevy the switch of management of lighting devices

CHECK

 PERFORMANCE ORDER

1. The combined pediculate switch is located on the left side of a steering column and provides management of functioning of indexes of turns / the alarm system, head headlights, a dimmer and parking fires.
2. Remove the switch.
3. By means of an ohmmeter or the lamp sampler equipped with the individual power supply check correctness of distribution of conductivity between switch plugs in its various provisions. In case of identification of violations replace the switch.

 

REPLACEMENT

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery and wait not less than three minutes before starting slip dismantle.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Remove a knee emphasis and covers of a steering column (see. Head Body).
3. Turn out fixing screws, disunite sockets of electroconducting and remove switch assembly from a steering column.

4. Installation is made upside-down.

Podruleva switch of management of functioning of cleaners/washers of a windscreen

CHECK

 PERFORMANCE ORDER

1. The switch is located under a steering wheel on the right on a steering column.
2. Remove the switch.
3. By means of an ohmmeter or the lamp sampler equipped with the individual power supply check correctness of distribution of conductivity between switch plugs in its various provisions. In case of identification of violations replace the switch.

 

REPLACEMENT

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery and wait not less than three minutes before starting slip dismantle.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Remove a knee emphasis and covers of a steering column (see. Head Body).

3. Turn out fixing screws, disunite sockets of electroconducting and remove switch assembly from a steering column.

4. Installation is made upside-down.

Switch of management functioning of a control system by the speed (tempostaty)

CHECK

 PERFORMANCE ORDER

1. On considered models the SET/RESUME switch темпостата is built in in a steering column whereas the main switch of system (ON/OFF) is on the dashboard, to the left of a steering wheel. The description of procedures of check and replacement of the main switch is provided the Section Check of serviceability of functioning and replacement of switches of the dashboard.
2. Remove the SET/RESUME switch from a steering column.

3. By means of an ohmmeter or the lamp sampler equipped with the individual power supply check conductivity existence between switch plugs in each of its provisions (see an accompanying illustration). In case of need replace assembly. If check confirms serviceability of the switch, however its functioning is broken, check a condition of the electroconducting connecting assembly to the control unit located under the dashboard.

REPLACEMENT

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery and wait at least three minutes before starting procedure performance.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Remove from a steering wheel the safety cushion module (see. Head Suspension bracket and steering).

3. Turn out fixing screws, disunite electric sockets and remove the switch from a steering wheel.

4. Installation is made upside-down.