Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Search of causes of failures of electric equipment
   Safety locks - the general information
   Chain breakers
   The relay - the general information and check of serviceability of functioning
   Check of serviceability of functioning and replacement of the breaker of indexes of turns / alarm system
   Check of serviceability of functioning and replacement of podrulevy switches
   Check of serviceability of functioning and replacement of the switch of ignition and lock of blocking of a steering column
   Check of serviceability of functioning and replacement of switches of the dashboard
   Check of serviceability of functioning of measuring instruments of a combination of devices
   Removal and installation of a combination of devices
   Removal and installation of a radio receiver and loudspeakers
   Removal and installation of the aerial of a radio receiver
   Replacement of lamps of head headlights
   Adjustment of the direction of optical axes of head headlights
   Replacement of block headlights
   Replacement of lamps
   Running fires of light time of day (DRL)
   Check of serviceability of functioning and replacement of the electromotor of a drive of screen wipers
   Check of serviceability of functioning and replacement of horns of a horn
   Check of serviceability of functioning and regenerative repair of a heater of back glass
   Control system of speed (темпостат) - general information and check of serviceability of functioning
   The electric drive of window regulators - general information and check of serviceability of functioning
   The uniform lock - general information and check of serviceability of functioning
   The electric drive of external rear-view mirrors - general information and check of serviceability of functioning
   Safety cushions - the general information
+ electric equipment Schemes





Removal and installation of the aerial of a radio receiver

 PERFORMANCE ORDER

1. Considered models of cars are equipped with the aerial of wire type fixed on back glass. The signal accepted by the aerial amplifies the electromagnetic coil established under the back shelf of salon.
2. At emergence of problems with reception of radio signals check conductivity existence in connecting electroconducting of the aerial.

3. Wrap up щупы an ohmmeter an aluminum foil and probe it threads of a reception lattice of the aerial. One щуп nestles on one of the aerial plugs, the second will see along lattice threads to identification of a point of break.

4. In case of break identification, restoration of a lattice is made in the manner similar to described in the Section Check of serviceability of functioning and regenerative repair of a heater of back glass for repair of a current-carrying lattice of heating of back glass.

5. If an accepting lattice as it should be, check a condition of the electromagnetic coil of the antenna amplifier. Disconnect from assembly of the amplifier two plaits of electroconducting. From the bobbin party of the 1-contact socket check existence between the unique plug and weight. If conductivity takes place, replace the coil.

For simplification of a rassoyedineniye of sockets release two clamps of fastening of a cover on the bottom party of the amplifier. Read out ohmmeter indications only some seconds later after its connection. During the first moment the device can fix conductivity which later can already reduce to zero 20 seconds. During this dough conductivity of the coil is checked also.

6. Make sure of lack of conductivity between two plugs of the 2-contact socket from the opposite side of assembly of the amplifier. If conductivity takes place, replace the coil (see. The remark to paragraph 5).

7. For replacement of the coil remove the back shelf (see. Head the Body) also give two fixing screws.