Honda Accord

1998-1999 of release

Repair and car operation



Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Removal and installation of assembly of the forward shock-absorber with a screw spring
   Replacement of the shock-absorber or screw spring of rack-mount assembly
   Removal and installation of a rotary fist
   Removal and installation of assembly of a forward nave with the wheel bearing
   Removal and installation of the forward stabilizer of cross-section stability
   Removal and installation of a pushing bar of a forward suspension bracket
   Removal and installation of the bottom control lever of a forward suspension bracket
   Removal and installation of the top control lever of a forward suspension bracket
   Replacement of spherical support
   Removal and installation of assembly of the back shock-absorber with a screw spring
   Removal and installation of stupichny assembly of a back wheel
   Removal and installation of assembly of a back nave with the wheel bearing
   Removal and installation of a bar of the back stabilizer of cross-section stability
   Removal and installation of levers of a back suspension bracket
   Removal and installation of a steering wheel
   Removal and installation of tips of steering drafts
   Replacement of protective covers of the steering mechanism
   Removal and installation of reechny transfer
   Removal and installation of the steering pump
   Air removal from a hydraulic path of system of strengthening of a wheel
   Wheels and tires - the general information
   Corners of installation of wheels
+ Body
+ Onboard electric equipment
+ electric equipment Schemes





Removal and installation of assembly of a back nave with the wheel bearing

The back nave is incorporated with the wheel bearing in uniform assembly. The bearing загерметизирован at manufacturer and additional greasing does not need. In case of wear or damage of the bearing it is necessary to replace it assembled with a nave.


 PERFORMANCE ORDER

1. Weaken nuts of fastening of the corresponding back wheel. To Poddomkratta a car back also establish it on props. Remove a wheel.
2. Remove a brake drum/support with a disk (see. Head Brake system).
3. By means of a hammer and a chisel remove a dustproof cover, then расчеканьте a stupichny nut.

4. By means of a face natural a long collar give a stupichny nut.

5. Remove a nave with the wheel bearing built in in it from stupichny assembly of the back bridge. If the nave "became attached", обстучите its hammer with soft the brisk.

6. Establish new assembly of a nave with the bearing on the regular place. With demanded effort tighten a new stupichny nut. Do not forget зачеканить a nut.

7. Establish into place a dustproof cover, for reliability of landing slightly обстучав it on perimeter.
8. Further installation is made as it should be, the return to an order of dismantle of components. Track, that the fixture of components of the brake mechanism was tightened with demanded effort (see. Specifications to Head Brake system). Efforts of a tightening of wheel nuts are given in Specifications to Head of Control and routine maintenance.